![]() ![]() If we use a memory buffer with 500 elements, thenĬheckpoint 14.1: Assume Xmin, Xmax, and dX are all given in the same units. ![]() To sample the ADC and calculate distance, the sampling rate, fs, is 10 Hz, and the time quantization is 1/ fs=0.1 sec. Time interval is the smallest to largest time during which we collect samples. Time quantization is the time difference between one sample and the next. In most systems, the resolution of the measurement is determined by noise and not the number of bits in the ADC. Theoretical resolution is 1.5cm/4095, or about 0.0004 cm. If there is no electrical noise and we use a 12-bit ADC, then the If a system has 12-bit precision, there are 2^12 or 4096 distinct alternatives.įor example if we use a slide pot to measure distance, the range of that pot might be 0 to 1.5cm. The units of precisionĪre given in alternative or bits. The following four limitations exist when sampling data.Īmplitude resolution is the smallest change in input signal that can be distinguished.įor example, we might specify the resolution as dX.Īmplitude range is defined as the smallest to largest input value that can be measured.įor example, we might specify the range as Xmin to Xmax.Īmplitude precision is defined as the number of distinct values from which the measurement is selected. Consider an entire system that collects data, not just the ADC. System has no actuator because it simply measures the measurand in Measurand in the real world to a desired value while the data x(t) is the time-varying signal we are attempting to measure. Figure 14.1 shows the data flow graph for a data Like sound, distance, temperature, force, mass, pressure, flow, lightĪcceleration. To measure distance to an object (EE319K skips this). Use the Central Limit Theorem to improve signal to noise ratio.Theorem to cases where we use the ADC to sense information. ![]() Quantization, range, precision and resolution. Transducers: conversion of physical to electrical.ĭigital computer to sense its analog world. We define the rate at which we sample as the sampling rate, and use the symbol fs.ĪDC, software, PWM output and motor interfaces to implement intelligent Interrupts to sample the ADC at a fixed rate. More specifically, we present a technique for theĪnalog inputs using an analog to digital converter (ADC). This chapter we will focus on input devices that we use to gatherĪbout the world. System uses its input/output devices to interact with the external Throughout this course we have seen that an Modified to be compatible with EE319K Lab 8 14: Analog to Digital Conversion, Data Acquisition and Control ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
December 2022
Categories |